I rode for them as a ‘Amateur’ skateboarder in ‘79-’80, and they, at that time, had one of the Best boards out on the market, made of Fiberglass in a torsion box, with a foam core, and urethane ‘bumpers’ all around. I still have that board, and one set of C-70 Reds from then. I skated that gear hard, for many years, too. I still own 6–7 full sets of “krypto’s” for skateboards, and 8 that’re on quad-roller-skates. Great wheels, and they’re still in use.
If you didn’t already know, the “nose” of a skateboard is typically the front and the “tail” is the back.  When you fall or slip and your board slams into curbs, fences, or other hard objects, it’s common for the wooden ends to chip or become damaged upon impact.  Over time these chips can make it harder to preform tricks and even just cruise around.  These chips can be prevented by buying a carbon fiber or non-wood deck, or by there are some metal edges available that can be installed on the nose and tail.
A precursor to the extreme sport of street luge, that was sanctioned by the United States Skateboarding Association (USSA), also took place during the 1970s in Signal Hill, California. The competition was called "The Signal Hill Skateboarding Speed Run", with several competitors earning entries into the Guinness Book of World Records, at the time clocking speeds of over 50 mph on a skateboard. Due to technology and safety concerns at the time, when many competitors crashed during their runs, the sport did not gain popularity or support during this time.[36][37]

The deck will also have a material on top called grip tape. This textured surface is what keeps your shoes from sliding all over the place as you ride. Look for a very high-quality grip tape for extra stability as you are learning, or something that is very visibly textured (like the waffletop from the pennyboard on our list above). You can also replace the grip tape if you love a board but don’t love the grip tape it comes with.
Grip tape adds additional assurance for a rider's feet. It is made from a sheet of colored paper or fabric with adhesive on one side and a fine, sand paper surface on the other. Applied to the top surface of a skateboard, grip tape gives a person's feet an improved grip while maintaining stability for performing tricks. Skateboard trucks connect both the wheels and ball bearings to the deck and are directly attached to the deck themselves. They are usually constructed from aluminum alloy. The wheels are mounted to their axles via steel bearings. The wheels are made from polyurethane and available in a range of different shapes and sizes to suit most any skill level.
If you are a beginner, the best thing you can do before you buy a board is to ask yourself what kind of skateboarding you want to do. Do you want to go cruising around a mostly flat area for fun? A longboard may be the best choice for you. Are you interested in learning tricks and stunts? A double-kick skateboard may be the best option. A classic skateboard is perfect for the rider that isn’t really sure what they want just yet.

It is mainly because those items are guaranteed to help you familiarize yourself with the ins and outs of using them. They are a big help in making you feel comfortable when you push off with your feet while also balancing on top of the board when riding. It is not good to go for a very technical product, so it’s best to choose the mentioned types first.

The best criticism you could make about skateboarding in general right now is that it takes itself too seriously. Rightfully so. Skateboarders are often under attack, and what they do is illegal in most places. Skate culture is constantly being ripped off and bastardized. That's why it's so important to have a healthy sense of humor about it all, and that's why it's important that skateboarding has Roger.
A skateboard consists of a deck, trucks, wheels, bearings, hardware, and griptape. All parts come in a variety of sizes, graphics, colors, and signature pro series. The deck is the essential part of any skateboard. The deck ranges generally from 7.5" to 8.5". Skaters choose their board size for many reasons, but the basic deciding factor comes down to style of skating and foot size. Transition skaters usually ride a wider deck, while street skaters tend to go with a smaller deck. Skate brands such as Girl, enjoi, and Welcome offer a wide range of boards in regards to sizes and graphics. Skateboard trucks come in either a high or low setting, and also in a range of widths. The main factors in a truck, are how well they turn, and how well they grind. Independent, Venture, and Thunder, are truck brands that are well known for their turning and grinding capabilities. The skate hardware is generally either Phillips head or Allen key bolts. The skateboard wheels range from 50mm to 60mm. Some brands offer smaller and larger sizes, but 50-60mm is the general range. Like the deck sizes, wheel sizes depend on the skater's choice of terrain: Transition skaters tend to ride bigger wheels, while street skaters usually go with smaller wheels. Bones, Spitfire, Ricta, and Wayward wheel companies all make wheels for any terrain, whether you're a street shredder or a park burner. Skate bearings follow the ABEC rating system, which includes grades 1, 3, 5, 7, and 9. Bones, Bronson, and Andale are some of the top bearing brands in the skate market. CCS proudly carries all these brands, and many more.
Distributed by NHS, Inc., Creature Skateboards was launched in 1994 by professional skateboarders Russ Pope, Jason Adams, Barket Barrett and Darren Navarrette. The company was revived in the mid-2000s. Creature is known for its horror themes on its skateboards and clothing. The company offers complete skateboards that include the decks, wheels, trucks, and bearings as well as customizable decks, and accessories. The Creature team includes 19 professional skateboarders. In addition to Navarrette, the roster includes such names as Al Partanen, Chris Russell, Cory Juneau and David Gravette.
With the evolution of skateparks and ramp skating, the skateboard began to change. Early skate tricks had consisted mainly of two-dimensional freestyle manoeuvres like riding on only two wheels ("wheelie" or "manual"), spinning only on the back wheels (a "pivot"), high jumping over a bar and landing on the board again, also known as a "hippie jump", long jumping from one board to another, (often over small barrels or fearless teenagers), or slalom. Another popular trick was the Bertlemann slide, named after Larry Bertelemann's surfing manoeuvres.
WKND turned a successful web series on the popular skateboarding site The Berrics into a company that is truly nothing but homies having fun and making videos they think are funny. Some people might dismiss them as another flash in the pan brand started by a crew of guys with some extra cash, but those same people have probably never watched American WKND and realized these guys are no fluke.
In most cases, it is available in black but you can also find clear ones that are ideal for you if you want to show a specific logo. Another nice choice that you have is the die-cut grip tape, which works in displaying the color or design of the deck beneath it. Make sure to choose a grip tape at a size, which perfectly suits your skateboard’s deck.
It’s a beautifully designed affordable skateboard that provides an optimum ride for both amateurs and pro riders. Its high-rebound, hand-cast polyurethane wheels are built to deliver best roll and grip during an action. Its 7.625 inches wide and 31.625 inches long top board offers ample grip and stable ride for the beginners who are still learning to stand while riding without any fear of slipping off the board. Its colorful screen-printed bottom lets you ride in style. It is built to meet demanding specifications.
Moose boards are very solid in all categories. They are low priced, available in a variety of different shapes and sizes, and have been around for a while so they’ve built up a reputable brand name. You won’t go wrong buying a pack of Moose blanks if you’re the type of guy that goes through decks quickly or is looking to resell them at your local skatepark.
In 1975 skateboarding had risen back in popularity enough to have one of the largest skateboarding competitions since the 1960s, the Del Mar National Championships, which is said to have had up to 500 competitors. The competition lasted two days and was sponsored by Bahne Skateboards & Cadillac Wheels. While the main event was won by freestyle spinning skate legend Russ Howell,[30][31] a local skate team from Santa Monica, California, the Zephyr team, ushered in a new era of surfer style skateboarding during the competition that would have a lasting impact on skateboarding's history. With a team of 12, including skating legends such as Jay Adams, Tony Alva, Peggy Oki & Stacy Peralta, they brought a new progressive style of skateboarding to the event, based on the style of Hawaiian surfers Larry Bertlemann, Buttons Kaluhiokalani and Mark Liddell.[32] Craig Stecyk, a photo journalist for Skateboarder Magazine, wrote about and photographed the team, along with Glen E. Friedman, and shortly afterwards ran a series on the team called the Dogtown articles, which eventually immortalized the Zephyr skateboard team. The team became known as the Z-Boys and would go on to become one of the most influential teams in skateboarding's history.[27][33][34]
Santa Cruz’s earliest videos Wheels of Fire (1987), Streets on Fire (1989), Speed Freaks (1989) A Reason for Living (1990) and Risk It (1990) are viewed today as paradigm-shifting releases which promoted interest in skateboarding globally by giving a platform to every kind of skateboarding that existed, from street and vert skating, through to the more niche genres such as slalom, downhill and freestyle, whilst at the same time retaining the aesthetic of skateboarding’s subcultural position in society.
Approximately two decades ago, a group of friends who were well versed in the world of skateboarding, set up their own brand; Plan B. Their knowledge and expertise helped them in setting up one of the best skateboard brands in the market with incredible gear. Not only does this Californian style skateboard company have the best-assembled skateboards, it is quite famous for its amazing decks. The customers of Plan B are literally head over heels for its amazing and durable decks. Plan B decks are made from thick 7 ply maple that gives it extra strength and minimal flexing.

Many cities also began implementing recreation plans and statutes during this time period, as part of their vision for local parks and communities to make public lands more available, in particular, for skateboarding, inviting skateboarders to come in off of the city streets and into organized skateboarding activity areas. By 2006 there were over 2,400 skateparks worldwide and the design of skateparks themselves had made a transition, as skaters turned designers.[43][60][61][62][63] Many new places to skateboard designed specifically for street skaters, such as the "Safe Spot Skate Spot" program, first initiated by professional skateboarder Rob Dyrdek throughout many cities, allowed for the creation of smaller alternative safe skate plazas to be built at a lower cost.[64] One of the largest locations ever built to skateboard in the world, SMP Skatepark in China, at 12,000 square meters in size, was built complete with a 5,000-seat stadium.[65]
To help you decide what designs you like most, we included various patterns and printings in our review section. From cherry blossoms to fiery dragons, from checkered boxes to padded pugs, there is a lot to explore. You have to remember that you will be using this skateboard for years/months to come. Therefore, it’s important to choose a design that you think is cool, not a design that will look cool to others!
Chocolate Skateboards is a skateboarding company distributed by Crailtap. Following on the heels of Girl, Chocolate was launched in 1994 by Mike Carroll and Rick Howard and is known by its Chocolate hearts logo. Their skateboards are made of durable seven-ply maple. Graphics are also important to the Chocolate brand, and you will find things such as classic cars or cartoons. You can find complete Chocolate skateboards with deck, trucks, wheels and bearings, customized decks, accessories, and apparel. The Chocolate team consists of Vincent Alvarez, Kenny Anderson, Chico Brenes, Justin Eldridge, Jesus Fernandez, Chris Roberts, Elijah Berle, Stevie Perez, Raven Tershy, and Jerry Hsu.
You know how people say shit like: Ernest Hemingway is “a writer's writer” and it's not really clear what that means, but you sort of get it? Well Anti-Hero is a skater's skate brand. Founded by underground hero pro skater Julien Stranger, Anti-Hero is a direct expression of his attitude towards the skate industry, which is basically that skateboarding is life and fuck everything else. Anti-hero has a reputation for being one of the gnarliest skate brands around, thanks in part to their team of heavies which includes John Cardiel, Tony Trujillo, and Chris Pfanner.
TIP: Extra width and short noses make old school boards more difficult to flip or lift off the ground, so they are not ideal for street skating. With some old school boards, the truck mounting holes are drilled to only fit certain trucks, so make note of the truck pattern before you buy the deck. If you’re not sure your trucks will fit, just give us a call and we’ll figure it out. Shop Old School Compatible Trucks
By the 1960s a small number of surfing manufacturers in Southern California such as Jack's, Kips', Hobie, Bing's and Makaha started building skateboards that resembled small surfboards, and assembled teams to promote their products. One of the earliest Skateboard exhibitions was sponsored by Makaha's founder, Larry Stevenson, in 1963 and held at the Pier Avenue Junior High School in Hermosa Beach, California.[12][13][14] Some of these same teams of skateboarders were also featured on a television show called "Surf's Up" in 1964, hosted by Stan Richards, that helped promote skateboarding as something new and fun to do.[15]
A “razor tail” is the term for when the tail of the skateboard deck becomes sharpened and worn due regular use and scraping the tail of your skateboard on the ground to stop.  When your deck gets razor tail, its becomes a weapon against you and anyone need you while you’re skating as being hit with a sharpened tail is very painful.  To avoid this from happening, you could buy a carbon fiber deck that may be more resistant to wear, but more importantly you should not scrape your tail to stop.  Instead you can lightly place one foot or toe down to slow your speed or powerslide to a stop.
Proper skateboard wheels are made out of polyurethane with minimal additives. Toy skateboard wheels can be made of plastic or a low quality poly mix which leads to poor performance in the best case and even outright dangerous situations with cracked wheels in the worst case. This is a case where brand recognition and reputation can come into play. 

These boards are perfect! perfect shape (for me anyways) medium concave (which is better than deep or mellow in my opinion) perfect shape of the tail and nose, and have perfect pop (which last FOREVER) they're very durable too. Everything is perfect but why they're ranked so low is because not many people get deluxe boards than come here to write about how awesome they are.

They have continued to ride that wave over the past year, continuously putting out great edits, following cherry up with Sickness, Red Devil, Joyride, and Swoosh, all in collaboration with cherry’s filmer Bill Strobeck. We all know they will never fall off when it comes to putting out fire gear every new season and drop, but to keep it coming with actual great footage is another story, and is definitely making skateboarding better today.

×